FEST3D 2018.02.00 SP2

FEST3D is a software tool capable of analyzing complex passive microwave components based on waveguide and coaxial cavity technology in very short computational times with high accuracy. This suite offers all the capabilities needed for the design of passive components such as optimization and tolerance analysis. Moreover, FEST3D advanced synthesis tools allow designing bandpass, dual-mode and lowpass filters from user specifications.

FEST3D is based on the integral equation technique efficiently solved by the Method of Moments. Additionally, the Boundary Integral-Resonant Mode Expansion (BI-RME) method is employed for extracting the modal chart of complex waveguides with arbitrary cross-section. The successful combination of such methods ensures a high degree of accuracy, as well as reduced computational resources (in terms of CPU time and memory) compared to mode-matching methods.
FEST3D analysis method is based on a multimode equivalent network representation of waveguide junctions. Each element in the complete circuit is solved with the best available method, ensuring both efficiency and accuracy. On this basis, FEST3D is able to simulate complex passive devices in extremely short times (of the order of seconds or a few minutes), whereas general purpose software (based on segmentation techniques such as finite elements or finite differences) can take hours for the same calculations.

On top of that, unlike mode-matching techniques, the electromagnetic algorithms employed in FEST3D minimize the problems of relative convergence, leading to confident results. Furthermore, the integral equation technique employed extracts part of the frequency dependent computations, thus allowing a very low computational time per frequency point when compared to standard mode-matching techniques. This benefit is more evident when high accuracy is required and, therefore, a large amount of electromagnetic modes are required to analyze the component.

Fest3D AnalysisSome of the components that can be analysed with FEST3D are:

Filters (Comb-line, Inter-digital, waffle-iron, dual-mode, band-stop, etc.)
Multiplexers (Diplexers, OMUX’s, etc.)
Couplers
Polarizers
OMT’s
FEST3D includes the possibility to automatically design several types of components from user specifications. Currently, the user can synthesize dual-mode filters, band-pass filters, low-pass filters and rectangular tapers.

During the synthesis stage, full-wave simulations are performed in order to consider the impact of non-propagative waveguide modes. Thanks to this and to the particular algorithms employed in each case, the synthesis process provides very good responses with respect to the user specifications without the need for post-optimization.

As well as the automatic generative design of specific components, FEST3D has an optimization tool for the refinement of the component geometrical parameters in order to get the final desired response. Several optimization algorithms are included in the tool (Simplex, Powell and Gradient). The progress of the optimization can be monitored in real time, as well as stopped, reconfigured and resumed from the Graphical User Interface at any time.

Fest3D DesignFEST3D also allows the user to easily perform sensitivity analysis of the final design. The user can choose which geometrical parameter/s to modify and the deviation of each one can be set separately.