Micromorphology and adhesive performance of Er:YAG laser-treated dentin of primary teeth

This study evaluated (1) the micromorphology by scanning electron microscopy (SEM) and (2) the adhesive performance by microtensile bond strength (ىTBS) of diamond bur-treated dentin compared to Er: YAG laser-treated dentin of human primary teeth. (1) For qualitative SEM evaluation, dentin of 18 second primary molars (n=3/method) was treated with either diamond bur as a control (group 1a: 40 ىm diamond bur only (clinical situation); group 1b: grinding+40 ىm diamond bur) or with Er:YAG laser (group 2a (clinical situation, manufacturer’s settings): 200 mJ/25 Hz (5 W) + 100 mJ/35 Hz (3.5 W) laser only; group 2b (experimental setting "high"): grinding+400 mJ/20 Hz (8 W); group 2c (manufacturer’s setting "finishing"): grinding+100 mJ/ 35 Hz (3.5 W); group 2d (experimental setting "low"): grinding+50 mJ/35 Hz (1.75 W)). (2) For evaluation of adhesive performance, 64 second primary molars were divided into four groups and treated as described for group 1b and groups 2b/c/d (n=16/method), and ىTBS of Clearfil SE/Clearfil Majesty Esthetic to dentin was measured. The SEM micrographs were qualitatively analyzed. The ىTBS values were compared with a Kruskal–Wallis test. The significance level was set at ل= 0.05. SEM micrographs showed the typical micromorphologies with a smear layer for the diamond bur groups and open dentin tubules for all laser-treated groups. However, in group 2d, the laser beam had insufficiently irradiated the dentin area, rendering the underlying ground surface partly visible. There were no statistically significant differences between ىTBS values of the four groups (p=0.394). This suggests that Er:YAG laser treatment of dentin of primary molars provides bond strengths sim